The Nantucket tutorials

Over the last I have been using the island of Nantucket (Massachusetts) as a sandbox to try all kind of autogen techniques and to develop new features of scenProc. Coincidentally Bill Womack is working on a scenery of Nantucket airport¬†as well. So my test autogen project will even end up in a real product. And […]

P3D v2 and GPW gaps

In my post from two days ago I reported about gaps in my ground polygons, this lead me to discover the different resolution of BGLComp and BGLC generated BGL files. But it turned out that the gap was also caused by a programming mistake I made. The round earth correction was not completely correct for […]

GPW update for P3D v2

I have just put an update of the ground polygon wizard (GPW) in the development release of ModelConverterX. With this update it is now possible to export P3D v2 MDL files from the GPW as well. These can be used in P3D v2 and it allows you to use the full material properties on your […]

GPW and P3D v2

Today I have been experimenting with updating the ground polygon wizard of ModelConverterX to also export P3D v2 MDL files for ground polygons. Given the recent announcement by Lockheed Martin that the FS2002 style polygons will be dropped in the future, it became time to update the GPW. The good news is that it was […]

RADItor update

I have made a small update for RADItor. When you drop a file on the EXE, shortcut or on the main form it will now automatically be loaded. So you don’t have to manually browse for the file anymore in that situation. The new version can be downloaded from the RADItor page.

Batch mode from command prompt

I already made these changes a few days ago in ModelConverterX, but since I didn’t write about them yet they probably went unnoticed by most of you. So let me document the changes I made to the batch mode. First I add a checkbox to the batch convert wizard that allows you to select if […]

Place points along line updated

I have updated the PLACEPOINTSALONGLINE step of scenProc today. So if you grab the new development release tomorrow you will notice that the step takes two more arguments. So your existing configuration files need to be updated! Please check the updated manual for all details of the changes. Below I will give a short summary. […]